Allen bradley hmi pv800 disable buttons6/10/2023 file and converted it to a Factory Talk mer. I thought the process was going to be straight forward just swap and go boy was I mistaken not only was the panel a upgrade but we had to get new editing software. Recently we replaced a HMI that had gone out and we upgraded to a fairly newer version our old unit was a PanelView 600 and we upgraded to a PanelView Plus 700. I am a begiiner at this so please bear with me. My Micro820's firmware is already upgraded to 10 as also the CCW is 10.001 Somebody that can test if the issue appear? Try to set the bit "Out_Act" and after that put some date setting on try to set the "RTC_Enable_Set" bit. Inside "Prog1" program I put the "Out_Act" to activate the output 00 and inside the "Date_Hour" I put the RTC_SET instruction. So i thinked that the problem is the Beijer sync method and I try to compile the simpliest program to test the issue. ![]() All works but if the sync come concurrently with an exited output the output relè seems to vibrate (anyway the related led stay on!). So I decide to sync it every hour with the Beijer one with the RTC_SET instruction block. I notice that the Micro820 internal RTC is not so accurate (as datasheet said). ![]() I use the Micro820 2080-LC20-20QWB (relay output) with a Beijer HMI panel. Hi! Here I am again but this time with Micro800 "issue".
0 Comments
Leave a Reply. |